Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
What should a person do/know before an AR build
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="briarcreekguy" data-source="post: 2816063" data-attributes="member: 16975"><p>In the video in the link above. The tech demonstrates using a special tool to install the spring and the front take down pin detente. He mentions that he made his from a punch. I had some quarter inch rod and was going to make the tool from that stock and then I looked around and found a cheap Chinese made Phillips screw driver with the correct diameter in my tool box. A minute with a dremel cut off tool, and a couple of minutes at the drill press drilling a small hole, and presto, I had the tool. Made installing the spring and detente pin a simple task. Proud to say that I didn't launch the pin once and didn't cuss it a bit.</p></blockquote><p></p>
[QUOTE="briarcreekguy, post: 2816063, member: 16975"] In the video in the link above. The tech demonstrates using a special tool to install the spring and the front take down pin detente. He mentions that he made his from a punch. I had some quarter inch rod and was going to make the tool from that stock and then I looked around and found a cheap Chinese made Phillips screw driver with the correct diameter in my tool box. A minute with a dremel cut off tool, and a couple of minutes at the drill press drilling a small hole, and presto, I had the tool. Made installing the spring and detente pin a simple task. Proud to say that I didn't launch the pin once and didn't cuss it a bit. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
What should a person do/know before an AR build
Search titles only
By:
Top
Bottom