Once I find some decent brass, I’ll go ahead and uniform the necks
Something else to check on your cases like you do not check enough things now.
Size of case after firing.
If you are anal about prep and measuring and annealing and get a flier or 2 in a group
mark those cases and measure the Neck OD and compare it with the other cases.
I have found some cases in the same lot will cause a flier and when I check neck OD I find it is different than other cases which makes me feel the alloy is not quite the same.
That is if every thing was done spot on the money.
I have read a bench rest shooter will take their cases and fire them and mark the fliers and shoot those marked cases again and make sure it was not the handloader error.
If they get a flier out of that case a second time that case is no longer allowed to play in the shoot some tight group games.
OOOHHHH So much work i almost hate it.
It was nice to get a couple 6.5x55 Swedish Mausers recently to play with though.
Stock trigger pull was brutal on one when trying to hold on target at 200 yards.
Trigger pull would move the aim point just a tick off target and the better trigger one has 6.7 lbs of pull and does the same thing but not as bad.
Now the bad trigger pull one is 2.6 to 2.7 lbs of pull. Clean break no grit or creep.
I am sure you got the trigger dialed in on your rifle.
Or hope so.
Size of case after firing.
If you are anal about prep and measuring and annealing and get a flier or 2 in a group
mark those cases and measure the Neck OD and compare it with the other cases.
I have found some cases in the same lot will cause a flier and when I check neck OD I find it is different than other cases which makes me feel the alloy is not quite the same.
That is if every thing was done spot on the money.
I have read a bench rest shooter will take their cases and fire them and mark the fliers and shoot those marked cases again and make sure it was not the handloader error.
If they get a flier out of that case a second time that case is no longer allowed to play in the shoot some tight group games.
OOOHHHH So much work i almost hate it.
It was nice to get a couple 6.5x55 Swedish Mausers recently to play with though.
Stock trigger pull was brutal on one when trying to hold on target at 200 yards.
Trigger pull would move the aim point just a tick off target and the better trigger one has 6.7 lbs of pull and does the same thing but not as bad.
Now the bad trigger pull one is 2.6 to 2.7 lbs of pull. Clean break no grit or creep.
I am sure you got the trigger dialed in on your rifle.
Or hope so.
Trigger is pretty critical for good shooting
I used to think it wasn't but I was only shooting 100 yards and happy with under 1" groups.
Once I began shooting for a good group at 200- 500 yards I found out how much you really pull the weapon off target and then need to readjust if the thing did not go off yet.
I would do a ladder load development procedure and go from there. This will help your accuracy at any range.
Norma brass tightened it up some, 5 shots at 100yds. Last shot was the lower shot, which I think was me( got a little nervous that I had such a good group,lol)
Very nice.
