Moving a safe

[doctorjj]

I can’t imagine the bolts won’t break with a good socket and 1/2” drive breaker bar. Tighten til they snap.

 

[Ignored Member]

There’s breaker bar, and there is the 4 foot BREAKER BAR that slides over the standard breaker bar ...that’s the system I’d use

I've snapped a couple breaker bars doing that, but if it doesn't snap, then it should do the trick just fine.

 

[davek]

What would Wile E. Coyote do?

 

[Mack45]

What would Wile E. Coyote do?

Check your Acme tool company catalog!

 

[MavMatt]

I have a small plasma cutter that will run on 110volt and for the right amount of beer I might be available this weekend.

 

[Snattlerake]

Call out the safe putterinner people. Ask them to be the takeroutter people.

 

[John6185]

Some of the guys at the Half-way House in OKC might have some knowledge... A guy can pay them $50 and I hear they'll do anything.

 

[SABOT]

Contact a safe company. Better to consult a real expert vs Internet expert.

 

[SoonerP226]

Steve's Wholesale Tools has some big dang breaker bars. I bought a 3/4"-drive breaker bar there that was about four feet long; one of those and an impact socket of the correct size should be enough to shear that bolt off. If not, add a cheater pipe.

Or try bassin's suggestion. That's probably going to be easier than fighting the bolts in the back corners.

 

[Perplexed]

I have a small plasma cutter that will run on 110volt and for the right amount of beer I might be available this weekend.

“Hold my beer and watch this!”