Looking for electrician in Edmond residential work.

[panayoti]

Need to have lightswitch replaced. I tried doing it myself but something else is going on. Not getting any power on hot lead. Double checked breakers GFI's.

 

[swampratt]

No power at light switch?
I have seen rooms wired where the plug in receptacle near the floor feeds power to the light switch and the wire connection there was at fault.

 

[audiotech]

Robert Baxter - About – Edmond Electrician – Electrical Contractor – Robert Baxter Electric

 

[panayoti]

Thanks audiotech

 

[panayoti]

The light is over the throne so no plugs near by. The plugs are by the vanity across the walkthrough area. I thought maybe the GFI ' s were messing me up but they test and reset properly.

 

[panayoti]

There is also a combo heat lamp exhaust fan about 4 ft from the light fixture however I didn't see a line going to the light.

 

[Sted-E Ed-E]

Is it the master bath? There may be another gfi in the closet somewhere.

A heat vent light should be on a dedicated circuit.

 

[John6185]

Speaking from experience, make sure the wires are twisted tight under the caps. That was my problem.

 

[swampratt]

My 1940's house just had a pull cord to turn on the light in the bathroom. No wall switch.
I added another pull cord and put in a fart sucker fan.
Your house sounds newer.

 

[audiotech]

Thanks audiotech

You’re welcome, they helped chase down a line and replaced a breaker for me last year. Very reasonably priced and honest