Picture of some of my 35 cal

[Old Fart]

Just saw these and thought I'd post it. Nothing special, just for comparison.

[Broken External Image]

35 Whelen, 35 Rem, 357 Max, 357 Mag, 38 Spl.

 

[Okie4570]

Nice............do you need a .350 Rem Mag cartridge for your collection? Haven't shot mine in a few years, got lots of ammo.

 

[Blitzfike]

I shoot the 357 mag, 38spl and I also shoot the 357 herrett. I love the Herrett, it is very close to your 35 rem in ballistics. I would have gone for it, but making the Herrett brass from 30-30 is just too easy.

 

[Old Fart]

From what I see around here some of the 35's are under appreciated. I've had nothing but good luck with my 35 Rem.
I picked the Whelen up from a forum member who also post on Greybeards and haven't shot it much yet.
But from what he's told me it is a go getter. I'm just going thru a phase of larger/older calibers right now.
The Max is something I've wanted for years and have just drug my boots on.

 

[swampratt]

Very neat assortment of ammo.
I like old ways...

 

[adluginb]

Love my .35 rem that use to be my dads.

 

[okietom]

I shoot the 357 mag, 38spl and I also shoot the 357 herrett. I love the Herrett, it is very close to your 35 rem in ballistics. I would have gone for it, but making the Herrett brass from 30-30 is just too easy.

Have you ever used .375 Winchester brass to form .357 Herrett cases? I am getting set up to try it. Just a few minutes ago I sent an order to Ch4d.com for a Dillon Trim die for my rapid trim. I am simply going to run the .375 brass into the rapid trim and that should be it.

That should even have the shoulder in the right place too.

 

[Johnny]

From what I see around here some of the 35's are under appreciated. I've had nothing but good luck with my 35 Rem.
I picked the Whelen up from a forum member who also post on Greybeards and haven't shot it much yet.
But from what he's told me it is a go getter. I'm just going thru a phase of larger/older calibers right now.
The Max is something I've wanted for years and have just drug my boots on.

What is your 357 Max. I have been wanting one for a while.

 

[Old Fart]

It's a 357 mag Handi rifle reamed out.

 

[Blitzfike]

Have you ever used .375 Winchester brass to form .357 Herrett cases? I am getting set up to try it. Just a few minutes ago I sent an order to Ch4d.com for a Dillon Trim die for my rapid trim. I am simply going to run the .375 brass into the rapid trim and that should be it.

That should even have the shoulder in the right place too.

No, I shoot the 375 win so I hate to mutilate the brass for it. I can make 375 win brass from 30-30, but the necks are a little thin. I much prefer to use the actual 375 brass for itself. I machined some expander rods to expand the case mouth up to 375 from 30-30, I do it in two steps. Making the herret brass from 30-30 is way easy for me with the same expanders.