My reloading bench is ready

[steelfingers]

Put the Forester single stage on the inline fabrication heavy duty base. Got my powder measure ready and other than making a shorter handle and bolting the press to the bench. I'm ready to go.
Well I also have to clean the bench that's on the left you don't see because it's covered with trash. Ha.
This was fun.

 

[DRC458]

Looking good!

 

[steelfingers]

Looking good!

Thanks

 

[steelfingers]

I'm setting the press aimed at an angle. If anyone has a suggestion on doing anything better, please do so.

 

[Cowcatcher]

I personally would want bench space on both sides of my press. You may be planning for that. Just throwing it out there.

 

[okierider]

I personally would want bench space on both sides of my press. You may be planning for that. Just throwing it out there.

+10000000...................

 

[okierider]

Also ,I have a small side table that my powder measure sits on. Any bouncing around throws the measure off and until I got the side table I spent a few every loading session waiting on the powder. Them electric doodads are a lot sensitive!!

 

[MacFromOK]

Congrats!

 

[indi]

Looks good! I would highly recommend a rcbs 3 way trimmer (trim, chamfer and deburr in one step)attachment for your Hornady trimmer and power adapter to use a power drill.

 

[dennishoddy]

Throw that danged stool away!! I use a leather reclining chair that is nap comfortable to sit in front of my loader. Get comfy and load more rounds.